No, no need for anything other than the in-built driver.
Pretty self explanatory once you config with the Davis driver.
##############################################################################
[Vantage]
# This section is for the Davis Vantage series of weather stations.
# Connection type: serial or ethernet
# serial (the classic VantagePro)
# ethernet (the WeatherLinkIP or Serial-Ethernet bridge)
type = ethernet
# If the connection type is serial, a port must be specified:
# Debian, Ubuntu, Redhat, Fedora, and SuSE:
# /dev/ttyUSB0 is a common USB port name
# /dev/ttyS0 is a common serial port name
# BSD:
# /dev/cuaU0 is a common serial port name
port = /dev/ttyUSB0
# If the connection type is ethernet, an IP Address/hostname is
required:
host = 10.10.10.10
######################################################
# The rest of this section rarely needs any attention.
# You can safely leave it "as is."
######################################################
# Serial baud rate (usually 19200)
baudrate = 19200
# TCP port (when using the WeatherLinkIP)
tcp_port = 22222
# TCP send delay (when using the WeatherLinkIP):
tcp_send_delay = 0.5
# The type of LOOP packet to request: 1 = LOOP1; 2 = LOOP2; 3 = both
loop_request = 3
# The id of your ISS station (usually 1). If you use a wind meter
connected
# to a anemometer transmitter kit, use its id
iss_id = 1
# How long to wait for a response from the station before giving up (in
# seconds; must be greater than 2)
timeout = 4
# How long to wait before trying again (in seconds)
wait_before_retry = 1.2
# How many times to try before giving up:
max_tries = 4
# Vantage model Type: 1 = Vantage Pro; 2 = Vantage Pro2
model_type = 2
# The driver to use:
driver = weewx.drivers.vantage
##############################################################################
On Wednesday, November 16, 2022 at 12:30:00 PM UTC-5 Kev D wrote:
> Hi Gary,
>
> I have just upgraded my setup to VP2, WifiLogger2, and Belchertown skin
> as well. Would you mind sharing your configuration setup in weewx to grab
> data from the WifiLogger2? Are you also using the interceptor driver for
> this config?
>
> Thanks!
>
> On Friday, February 11, 2022 at 9:00:57 AM UTC-5 [email protected] wrote:
>
>> With the rapid succession of releases, I just wanted to say that my
>> upgrade to 4.6.2 went well and all is working with the VP2, WifiLogger2,
>> and Belchertown skin.
>>
>> Thanks for an amazing system!
>>
>
--
You received this message because you are subscribed to the Google Groups
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
To view this discussion on the web visit
https://groups.google.com/d/msgid/weewx-user/ac88d0b0-6adf-4048-8359-b031954f188an%40googlegroups.com.
