I have been running WeeWX with a Davis WLL and a Vantage Pro 2. https://wx-watch.co.uk/weewxu/
I recently got a Ecowitt Wittboy with extra sensors and decided to try the GW1000 driver. I installed WeeWX and copied the config and data from the above setup across. Then I installed the GW1000 and then edited to names of my extra sensors. A couple of questions (simple answers please as I am not very good at this) Under Sensor Status and Connectivity it is showing Signal Quality N/A - this I presume is left over from the Davis WLL setup. Can the GW1000 driver show signal quality and if so how - if not how can I stop it displaying this. Also Console Battery and Console Voltage (again left over from the WLL I presume) are N/A - can I show the voltage go the Wittboy Sensors and if so how or again how do I remove it https://wx-watch.co.uk/weewx/ Thanks -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to weewx-user+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/8767cf51-54ca-442c-9da8-fedf201b1d13n%40googlegroups.com.
