Thinking more, I am pretty sure the alpha code won’t work for you. - rich
On Friday, 5 March 2021 at 09:58:38 UTC-5 [email protected] wrote: > Christian, > I’d recommend adding ‘append_units_label = False’ on the publish side. > This will stop the appending of units to the label and you won’t have to > rename them on the subscribing side. > > I’d expect the subscribing config to look something like this. > > [MQTTSubscribeDriver] > driver = user.MQTTSubscribe > > host = > > [[message_callback]] > type = json > > [[topics]] > unit_system = METRIC > [[[weather/loop]]] > > If you post the log from startup through one archive period, I could dig > deeper. > > Important note, with the set up above, I believe you are publishing > archive records. These are received and put into loop packets by > MQTTSubscribe. WeeWX would then create archive records out of them. I think > this should all work, but there might be some timing issues. The log would > show what is going on. > I do have alpha/experimental code that would receive the MQTT payload and > process it as an archive record. It would very much be “use at your own > risk”. > - rich > > On Friday, 5 March 2021 at 09:05:50 UTC-5 [email protected] wrote: > >> ok, i installed the receiver Weewx new from scratch. No it seems to work >> without errors. >> I See in the (debugLevel 2) the incoming MQTTValues. But they don't where >> displayed in the screen. It seems, there is one point missing. >> >> Regards >> Christian >> >> [email protected] schrieb am Freitag, 5. März 2021 um 14:32:15 UTC+1: >> >>> a driver creates the original packet with a timestamp, a service changes >>> (usually adds to) the existing packet. >>> some modules, like gw1000, can be configured to be in either mode (i.e. >>> originate packets, or augment existing packets produced by some other >>> driver). i do this, with vantage as driver and gw1000 in service mode >>> >>> On 5 Mar 2021, at 10:59 pm, Christian Radermacher < >>> [email protected]> wrote: >>> >>> In which case I user Service, in which case I use driver? >>> >>> >>> -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/cc6358bb-b261-406e-bd07-1084839d9162n%40googlegroups.com.
