Did you do step #4? sudo wee_config --reconfigure --driver=user.wmr200 --no-prompt
On Sat, Jan 23, 2021 at 9:16 AM Invisible Man <axelle.apvri...@gmail.com> wrote: > > I’m not sure why you keep mentioning simulator (as in > extension/simulator). > > Because the doc https://github.com/weewx/weewx-wmr200 says "Install > WeeWX, selecting 'Simulator' driver. See directions at > http://weewx.com/docs/usersguide.htm#installing"; > > >driver = simulator > > No, I don't have "driver = simulator", but I have: > > station_type = Simulator > > [Simulator] > driver = weewx.drivers.simulator > > Is that normal ? > > On Saturday, January 23, 2021 at 5:58:38 PM UTC+1 jo...@johnkline.com > wrote: > >> I’m not sure why you keep mentioning simulator (as in >> extension/simulator). >> >> Do you have the following line in your weewx.conf? >> >> driver = simulator >> >> If so, it should not be there. >> >> On Jan 23, 2021, at 8:49 AM, Invisible Man <axelle....@gmail.com> wrote: >> >> >> >> Hello, >> >> My outside temperature, my barometer, my dew point, my gust wind are >> completely crazy! >> >> Important: this happened after an upgrade from 4.2.0 to 4.3.0, where I >> had to install the WMR200 extension as it is no longer in the main weewx in >> 4.3.0. So please consider something might be wrong with my config for the >> extension/simulator. >> >> Also, I used to use Python 2.7 and have shifted to Python 3.x. So, that >> also might be a source of issue. >> >> My configuration is : >> >> - WMR200 station (using weewx-wmr200 extension) >> - My original WMR200 temperature sensor is KO and I have "replaced" >> it with a DIY sensor that sends its data using MQTT. Thus the MQTT >> extension. >> - My wind battery and my UV battery are low (but I wonder if it's not >> just a detection issue, because they are always low even when I change >> batteries). >> - I attach my weewx.conf >> >> >> *Temperature: * >> >> The current outside temperature is 9°C. You see below that I receive a >> MQTT message saying it is 9.14. Unit is degrees celsius. This is okay. >> >> Jan 23 17:10:22 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> MessageCallbackProvider data-> incoming topic: temperature/jardin, QOS: 0, >> retain: 0, payload: b'9.14' >> Jan 23 17:10:22 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> TopicManager data-> incoming temperature/jardin: outTemp: 9.14 >> Jan 23 17:10:24 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> TopicManager data-> outgoing temperature/jardin: dateTime: >> 1611418222.9963524, outTemp: 9.14, usUnits: 16 >> >> I also have an 'accumulated temperature'. Don't know exactly what that >> is, and I'm surprised usUnits is 1. Strange. >> >> Jan 23 17:10:24 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> TopicManager data-> outgoing accumulated temperature/jardin: dateTime: >> 1611418225.0, outTemp: 48.452, usUnits: 1 >> >> A bit later, I have this kind of messages: >> >> - outTemp is 48.452. For some reason, this is Fahrenheit. Indeed >> 48.452F=9C. >> >> Jan 23 17:10:24 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> data-> final packet is 2021-01-23 17:10:25 CET (1611418225): barometer: >> 31.042868851248706, consBatteryVoltage: 12.564392224893147, dateTime: >> 1611418225.0, heatingVoltage: 12.0, inHumidity: 27.78003341310109, inTemp: >> 64.10998329344946, inTempBatteryStatus: 0, outHumidity: 78.28606553746118, >> outTemp: 48.452, outTempBatteryStatus: 0, pressure: 31.042868851248706, >> radiation: 46.14176895043754, rain: 0, rainBatteryStatus: 0, >> referenceVoltage: 12.0, rxCheckPercent: 36.11042934389155, supplyVoltage: >> 12.0, txBatteryStatus: 0, usUnits: 1, UV: 0.6459847653061255, >> windBatteryStatus: 0, windDir: 349.7163932247671, windGust: >> 0.34278689250776395, windGustDir: 349.7163932247671, windSpeed: >> 0.28565574375646996 >> >> My report in my template displays $current.outTemp to "-0.9°C" !!! This >> not 9C, nor 48F :( >> >> *Barometer* >> >> On the WMR console, barometer indicates approx 980 mbar. >> Why does this log say 31??? Other unit? >> >> Jan 23 17:10:24 vegan weewx[18515] DEBUG user.MQTTSubscribe: (Service) >> data-> final packet is 2021-01-23 17:10:25 CET (1611418225): barometer: >> 31.042868851248706, >> >> My report displays $current.barometer to 1053 mbar !!! This is not 980 !! >> >> *Wind gust* >> >> I have currently 3/5 km/h. But my report says 0 km/h. It could happen >> that at a given time it is zero, but still I am suspicious about the value. >> >> I think there's a configuration issue somewhere in my files. This is >> crazy. >> >> >> -- >> You received this message because you are subscribed to the Google Groups >> "weewx-user" group. >> To unsubscribe from this group and stop receiving emails from it, send an >> email to weewx-user+...@googlegroups.com. >> To view this discussion on the web visit >> https://groups.google.com/d/msgid/weewx-user/477cec36-536b-4d10-a095-ebc732e09548n%40googlegroups.com >> <https://groups.google.com/d/msgid/weewx-user/477cec36-536b-4d10-a095-ebc732e09548n%40googlegroups.com?utm_medium=email&utm_source=footer> >> . >> <weewx.conf> >> >> -- > You received this message because you are subscribed to the Google Groups > "weewx-user" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to weewx-user+unsubscr...@googlegroups.com. > To view this discussion on the web visit > https://groups.google.com/d/msgid/weewx-user/6a24ee31-18e1-4c6f-93a3-bde38084b3b0n%40googlegroups.com > <https://groups.google.com/d/msgid/weewx-user/6a24ee31-18e1-4c6f-93a3-bde38084b3b0n%40googlegroups.com?utm_medium=email&utm_source=footer> > . > -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to weewx-user+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/CAPq0zEALgW827JNAy4sv1eEa-%2B3H908oT1J9rE-fsYhVSL-6Tw%40mail.gmail.com.
