Thanks for the reply. I did check the weewx.conf file and and found that
wind chill should be coming from the VP2. See below. I believe your comment
about when wind chill applies is only for the case where weewx calculates
the result. The VP2 does not have the restriction of being below 50deg.
Note that if I use the software supplied by Davis (WeatherLink), it will
display the wind chill data that matches what is displayed on the console.
Is there something else I may be missing?
[StdWXCalculate]
[[Calculations]]
# How to calculate derived quantities. Possible values are:
# hardware - use the value provided by hardware
# software - use the value calculated by weewx
# prefer_hardware - use value provide by hardware if available,
# otherwise use value calculated by weewx
pressure = prefer_hardware
barometer = prefer_hardware
altimeter = prefer_hardware
windchill = prefer_hardware
heatindex = prefer_hardware
dewpoint = prefer_hardware
inDewpoint = prefer_hardware
rainRate = prefer_hardware
On Friday, July 24, 2020 at 11:03:45 AM UTC-7, brisguy foo wrote:
>
> Hello all,
>
> I have been using weewx (3.9.2.1 with standard skin) successfully for
> several months now and just noticed that the wind chill graph does not
> reflect the values reported by my VP2. It always matches the outside temp
> values. I have seen that weewx can calculate wind chill on its own, but
> since the VP2 provides this data, I was expecting weewx to use it. Does it?
>
> Thanks
>
--
You received this message because you are subscribed to the Google Groups
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to weewx-user+unsubscr...@googlegroups.com.
To view this discussion on the web visit
https://groups.google.com/d/msgid/weewx-user/561d6cb4-b7bf-400a-a017-511f545ea40do%40googlegroups.com.
