Hello, I have one of the Froggit (Fine Offset) clones from Conrad.
I have used a similar setup as it was described before, but the only difference, that I have used a wifi AP a way to pass packet through it. I've done my whole project with a Raspberry Pi Zero W. There is a way to create a wifi access point with the Raspberry Pi and pass all data to your normal network. Then you set up interceptor in sniffer mode. It decodes all the packets what is sent from the weather station to WU. If you use a Raspberry Pi 3 or 3+ you can do the same by combining the wifi and the ethernet port. Wifi as AP and ethernet to your normal network. But an AP and Client combination works too the same way as on the Rpi0w. In my setup there was no need to define iptables in the router (and change firmware on the router). The Raspberry Pi does everything. It runs WeeWX too. Best Regards, Gábor Szabados -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/9fe94f3b-133a-45db-bf72-56403a85a4da%40googlegroups.com. For more options, visit https://groups.google.com/d/optout.
