Just curious - how did you start weewx when this happened? On Wednesday, November 21, 2018 at 9:11:36 PM UTC-5, David Beach wrote: > > My Vantage Vue station, weewx and my RPi run fine but from time to time I > experiment with another RPi to try out new things, usually using Simulator > as my input. > > A day or two ago, I put a fresh copy of the latest Raspian (which I think > was released just last week - maybe a bad idea!) on an SD card, added the > modifications for a RTC, installed nginx and then installed weewx using > setup.py. All seemed fine. When I manually fired up weewx, what looked like > simulated data began scrolling by on the terminal. I finally stopped it > using Cntrl-C. Same thing when I restarted again. > > I have never had this happen before. Does anyone recognize this as a > simple problem - with a simple solution? > > I don't want anyone to spend much time trying to figure this out. The > issue seemed so dramatic with screens of data spewing past, I thought > someone might recognize the issue. Since I have done so little > customization, it may be simpler to start from scratch rather than spending > a lot of time trying to ferret out an obscure error if it isn't obvious. > > Using the latest release of Raspian may not have been the smartest thing > to do, either! I don't think I need any of the latest features so if that's > the problem, I can go back to an earlier version. > > Thanks again, guys and gals. > > David >
-- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. For more options, visit https://groups.google.com/d/optout.
