On Tuesday, September 20, 2016 at 9:52:56 PM UTC-4, DD CC wrote:
>
> I have tried using sudo wee_config_fousb --slp=xxxx.xx but always get
> back wee_config_fousb command not found.
>
which version of weewx are you using?
the wee_config_fousb utility should be located in the bin directory,
nominally /home/weewx/bin/wee_config_fousb if you installed using setup.py
however, the wee_config_fousb utility was replaced by wee_device quite some
time ago
also, the --slp option no longer exists. instead, if you need to calibrate
the pressure sensor, enter the pressure offset in the calibration section
of weewx.conf:
[StdCalibrate]
[[Corrections]]
pressure = pressure + x
--
You received this message because you are subscribed to the Google Groups
"weewx-user" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
For more options, visit https://groups.google.com/d/optout.
