I think it is much simpler than people assume here. I have seen many users not Python experts, comeing from compiled languages, they click on [bytecode compile] at every change. That is not necessary here. That is a optional locking mechanism not a required step.
On 15 Ago, 21:42, mart <msenecal...@gmail.com> wrote: > Are you referring to the byte-compiled (.pyc) version of your code? > and that your changes to .py are not being picked up @ run time and > \the expected results are either lagging nor just plainly not showing > up? Are these your own modules that you are making reference to > outside of a controller's scope? > > typically, even if foo.pyc if found living side by side with foo.py, > the time required to compile the .pyc is actually recoded and stamped > inside the .pyc. If a mismatch in the time taken to compile found, > then foo.pyc will be ignored, so in this sense compile errors, are not > necessarily a bad thing. I am no means a web2py expert, but i do use > Python quite a bit and while trying my hand web2py, I do make tones of > changes (mostly correcting mistakes ;) ), and .pyc don't get > generated @ dev time. I wonder if there may be a call to force compile > your .py files? But regardless, I would investigate outside of the > web2py environment to isolate the pure python calls of your code from > wev2py (something i do every now and again - specially when I know > that the issue is in my own modules that I import) > > if this is in fact the case, python.org does have a good section on > modules > > http://docs.python.org/release/2.2.3/tut/node8.html#SECTION0084100000... > > Hope it helps, > > Mart :) > > On Aug 15, 9:58 am, DenesL <denes1...@yahoo.ca> wrote: > > > > > Hi firedragon852, > > > On Aug 14, 9:02 pm, firedragon852 <firedragon...@gmail.com> wrote: > > > > I am doing development under windows so I am running the binary > > > version of web2py for windows. > > > > It seems that whenever I change my code I need to clean/compile via > > > the admin interface for the changes to be effective. > > > > Is there a way to turn this off? During development I want to be able > > > to make changes in the code (*.py and *.html), reload the web pages > > > and see the changes immediately. > > > Where are you changing your code? > > *.py files changes in models? modules? controllers? > > Modules might need a local_import. > > Changes to *.html in views should be picked up immediately. > > > > I read the documentation many times but couldn't find any relevant > > > information on this. I also searched this group for clues but > > > couldn't find anything either.- Nascondi testo citato > > - Mostra testo citato -
