I recently setup a VPS host over at Santrex.net for testing web2py. It took me about two shifts to get Cherokee installed and running with Web2Py. What a pain. For those others that seemed to miss "libcherokee-mod-libssl" that was a painful lesson that could have been remarked elsewhere and saved a lot of time.
One of the things I noticed was that while working on the server that sometimes I could get the HTML source output starting with a "0" followed by the headers and then the page content. Ultimately this would cause an error and the page would fail to load. I noticed this happened about every 10th request or sooner depending on the speed at which I was moving through the site. Fed up with this problem, I decided to install Apache server and configure a VirtualHost. This installation took about 20 minutes including apt-get, ssl gen, and virtualhost setup etc. It also works flawlessly even though it is a touch slower for what I am working on right now. Do any other people here use Cherokee? Is it worth my time to chase down this page display problem? The only drawbacks for Apache with me are the default memory configuration issues (it's a pig out of the box on a vps and limited if your memory is limited) and that it happens to be the slowest, as far as I can see, based on performance reports. That being said it's still rock solid when it comes to working with Web2Py. --~--~---------~--~----~------------~-------~--~----~ You received this message because you are subscribed to the Google Groups "web2py-users" group. To post to this group, send email to web2py@googlegroups.com To unsubscribe from this group, send email to web2py+unsubscr...@googlegroups.com For more options, visit this group at http://groups.google.com/group/web2py?hl=en -~----------~----~----~----~------~----~------~--~---
