Robin,
"The cost of developing the prototype is estimated at between $100,000
and several million"
Check out Brad Lowe's images of his garage set up. You can do it for
much less.
http://ecatbuilder.com/builders/bhlowe
"H is the heat transfer agent. Not good.
Why is this not good?"
Read how Dale G.Basgall blew up his leg and was carted off to the
hospital crying. My own personal work with high pressure hydrogen under
elevated temperatures was ultra dangerous and unpredictable.
According to Chan: "4. Mix molar % of MgH2 30 (100% excess) Ni 30, Cu
20, Fe 20 in glove box. You might try igniter such as ANTIMONY
TRISULFIDE or LITHIUM BOROHYDRIDE in tiny catalytic amounts."
Rossi probably noted this and "invented" a new ECat devise cartridge
probably containing a hydride to avoid the use of hydrogen gas.
Is this what you are after: ("This document describes a project for the
development of a small prototype fusion reactor, incorporating a
completely new paradigm. "
http://rvanspaa.freehostia.com/project.html) ?
Start immediately after studying Wladimir Guglinski and Frank Znidarsic.
Jones enjoys ridiculing , perhaps. Ignore adverse comments by others and
push on. I wish to encourage you and anyone else to get your feet wet,
so to speak in this incredible new era about to explode and change life
as we know it.
Reality
[email protected] wrote:
In reply to Jones Beene's message of Sat, 25 Feb 2012 08:35:11 -0800:
Hi,
[snip]
-----Original Message-----
From: [email protected]
Robin: (Snip)
