On Sun, Nov 20, 2011 at 11:38 PM, Joshua Cude <[email protected]> wrote: > If this is the case, then the output mass flow rate has no relation > to the input mass flow rate, and the power output calculation using > the input flow rate is meaningless.
Save for what was required to fill the pipes and the devices, the input mass flow rate is obviously equal to the output mass flow rate. What I meant is that the flow rate may have been lower at the beginning during the starting phase. Maybe it was zero. Maybe it was very low, just enough to keep a sufficient water level in the reactors. When the reaction then starts, you start increasing the input mass flow rate to match the vaporization capacity. Here is such a scenario: 1) Each module contains a given amount of water. 2) Water flow is initially zero. 3) The reaction slowly ramps up in power. 4) Water temperatures in the modules rise. Steam production starts little by little and the sensed "output steam temperature" increases. 5) The output power is now sufficient to vaporize water at 675 l/h. 6) Pumps are turned on. Flow rate matches vaporization capacity. 7) Condensed, warm water starts flowing back into the reservoirs. The input temperature rises by a few degrees. -- Berke Durak

