Yes it looks a mess but just created a lot more energy than was
inputted, so fair go. As for the fin design, I could do better 40 years
ago. I mean the water enters in the lower left corner at the bottom and
the steam exits at the upper right on the top. I assume the rate of
water flow through that box is slow and if so the fin orientation is not
that important. Still it would not be hard to do a better job, he says
inside a fire proof suit having yet to build and then to get working a
LENR device ;)
This E-Cat is like a very early model T prototype. It works but boy is
there a lot that can be done to reduce cost and improve performance,
which is exactly what a engineering in a hurry would have built.
AG
On 11/9/2011 12:18 PM, Jed Rothwell wrote:
Aussie Guy E-Cat <[email protected]
<mailto:[email protected]>> wrote:
Some more inside shots
http://www.nyteknik.se/incoming/article3295952.ece/BINARY/w468/kall_fusion_rossi_sprattad_lada_1_468_320.jpg
That's a good photo.
Boy, what a mess! It looks like an old automobile radiator. It must
have been run for a hundred hours.
