A single laser source with dual outputs as suggested in the wiki
snip below would be better -one from either side of the lasers resonant
cavity ---[]---  used to form a counter propagating ring will produce a
phase shift in fringe pattern when rotated

[ wiki snip.]  where the Sagnac effect manifests itself in a setup called
ring interferometry. A beam of light is split and the two beams are made to
follow a trajectory in opposite directions. To act as a ring the trajectory
must enclose an area. On return to the point of entry the light is allowed
to exit the apparatus in such a way that an interference pattern
<http://en.wikipedia.org/wiki/Interference_pattern>  is obtained. The
position of the interference fringes is dependent on the angular velocity of
the setup. This arrangement is also called a Sagnac interferometer.

A device related  to the ring laser gyro is the fiber optic gyroscope which
also operates on the basis of the Sagnac effect, but in which the ring is
not a part of the laser. Rather, an external laser injects
counter-propagating beams into an optical fiber ring, and rotation of the
system then causes a relative phase shift between those beams when
interfered after their pass through the fiber ring proportional to the rate
of rotation. This is therefore less sensitive than the RLG in which the
externally observed phase shift is proportional to the accumulated rotation
itself, not its derivative. However the sensitivity of the fiber gyro is
enhanced by having a long optical fiber coiled for compactness, but in which
the Sagnac effect is multiplied according to the number of turns. [ /wiki
snip.]  

Fran

See http://en.wikipedia.org/wiki/Sagnac_effect  and
http://en.wikipedia.org/wiki/Ring_laser_gyroscope   

 

 

 

Re: [Vo]:Detecting absolute motion

Harry Veeder
Sat, 23 Apr 2011 23:44:03 -0700

Mauro wrote:

 

 

> I was just trying to emphasize, perhaps not a very good or 

> clear way, that there are no relative velocities of the two clocks
involved.

> 

> 

 

 

  

 

What matters is that when the clocks are together and are both at rest in
the 

same frame

they are both ticking at the same rate. The clock faces do not need any 

numerals 

initially.

 

It doesn't matter if the clocks speed up or slow down as they are being 

spatially separated, because once they are both at rest again in the same
frame 

they will both be ticking 

 

at the same rate.

 

However, prior to separating the clocks, scientists A and B agree that "12 

o'clock" will be 

 

where their respective clock hands happen to pointing after they have
reached 

the separation distance and A yells out to B . When B hears A he will know
he 

has to turn back his clock the amount of time it took A's voice to reach 

him (the separation distance divided by the speed of sound). The clocks will


then be sychronized.

 

 

 

Harry

 

 

Reply via email to