that is also the way I see it. Otherwise you would need two copper
components - inner Cu tube, stainless and then the outer Cu tube - A
stainless reactor chamber inside a widen part of one copper component would
be much easier to machine.
Dennis C
--------------------------------------------------
From: "Terry Blanton" <[email protected]>
Sent: Wednesday, April 06, 2011 5:37 PM
To: <[email protected]>
Subject: Re: [Vo]:Swedish physicists on the E-cat: "It's a nuclear reaction"
/ The used powder contains ten percent copper
On Wed, Apr 6, 2011 at 7:17 PM, Jones Beene <[email protected]> wrote:
It looks to me like the water inlet goes through the center of the
reactor.
This would likely be a copper pipe along the axis, surrounded by the
nickel
powder. Copper ions would immediately start to migrate when heat was
applied
to the outside of the reactor. Did you enlarge the pictures? There is
lots
of detail. The water has to go through the reactor, and the simplest way
is
a Cu pipe down the axis. Why is that problematic?
The conditioning time could be a day or two - and this would be needed
anyway. Arata, Kitamura, Takahashi all talk about conditioning the
powder.
Of course, Rossi might be trying to disguise the fact that he is
'seeding'
the nickel from the start, in addition.
Because that is not what I envision. I envision a SS reactor vessel
enclosed within a copper sphere attached to a copper pipe. The
reactor vessel is suspended inside the copper and the water passes
outside the SS reactor. Water does not enter the reactor vessel but
passes around it. Otherwise, how do you maintain the H2 pressure?
T
