Is this a misdirection or could the drive also be needed to prevent the sort of runaway we saw in Rayney nickel? First the drive aids in causing the effect - perhaps triggering an avalanche and then slaves the energy release to a certain duty factor? Fran
Daniel G. Zavela January 15th, 2011 at 4:28 AM Greetings from California and congratulations on your successful work! Can you simply state what the Watts IN are versus Watts OUT? Can you turn off the input current? Does the reaction become self-sustaining? Andrea Rossi January 15th, 2011 at 5:05 AM Dear Mr Daniel Zavela: Watts in: 400 wh/h Watts out: 15,000 wh/h Yes, we can turn off the input current, but we prefer to maintain a drive and the reasons are very difficult to explain without violating my confidentiality restraints. The reaction becomes self sustaining. Warm Regards, A.R. <end> COP = 37.5 T ----- Original Message ----- From: Peter Gluck<mailto:[email protected]> To: [email protected]<mailto:[email protected]> Sent: Monday, January 17, 2011 12:53 PM Subject: Re: [Vo]:Rossi Responds This heat was removed by condensing the steam- by the cooling water. Peter the Older On Mon, Jan 17, 2011 at 1:45 PM, P.J van Noorden <[email protected]<mailto:[email protected]>> wrote: Hello, What I don`t understand is that with this system producing 15 kW of power the temperature in the room isn`t higher then 23 degrees Celcius. This amount of power corresponds to a group of 150 people or an intense perpendicular solar flux through a large window of 15 m2. It seems that everybody in the room during the Rossi experiments was feeling very comfortable. Normally when such an amount of heat is dumped into a room the aircon will fail. Peter ----- Original Message ----- From: "Terry Blanton" <[email protected]<mailto:[email protected]>> To: <[email protected]<mailto:[email protected]>> Sent: Monday, January 17, 2011 1:50 AM Subject: [Vo]:Rossi Responds Three pages of questions and answers at his weblog: http://www.journal-of-nuclear-physics.com/?p=360&cpage=3#comments including: Daniel G. Zavela January 15th, 2011 at 4:28 AM Greetings from California and congratulations on your successful work! Can you simply state what the Watts IN are versus Watts OUT? Can you turn off the input current? Does the reaction become self-sustaining? Andrea Rossi January 15th, 2011 at 5:05 AM Dear Mr Daniel Zavela: Watts in: 400 wh/h Watts out: 15,000 wh/h Yes, we can turn off the input current, but we prefer to maintain a drive and the reasons are very difficult to explain without violating my confidentiality restraints. The reaction becomes self sustaining. Warm Regards, A.R. <end> COP = 37.5 T
