3.3.3r7 server on NT
1.2.1.0 Viewer from Tridia on Win98
Most of the time, but not all the time, ctrl-esc esc does not get me out of
full screen mode. When this happens Ctrl-alt-del is also disabled. If I have
managed to get into a login screen on he server side then then I am dead. I
can't send ctl-alt-del to the server to log in. ctl-alt-del won't reboot the
client. ctl-esc esc doesn't bring up the menu as it should. My only way out
is the reset button.
Normally the way I terminate the session is by killing the client from the
server side. It is only a problem if my screen saver kicks into password
protected screen protection mode.
Basically everything works from a clean powerup but eventually it gets into
the ignore special character mode. It seems like rebooting the server is
what clears the problem.
Is this a known bug? Is there an alternatitive way of getting control back
on the client side without resorting to a power cycle?
I am also having problems seeing the cursor in some exotic applications.
Instead of the cursor motion I see the numeric keypad equivalent number even
though I am using the alternate cursor key set not on the numeric pad. Again
it works from a clean boot of the server but eventually goes away.
I haven't noticed whether both of these key handling problems happens at the
same time. NOTE: I switched to the tridia viewer in hopes of fixing the
problem but the behavior did not change. This is consistant with it being a
server problem, i.e. rebooting the server temporarily fixes the problem.
Regards,
Steve Morris
---------------------------------------------------------------------
To unsubscribe, send a message with the line: unsubscribe vnc-list
to [EMAIL PROTECTED]
See also: http://www.uk.research.att.com/vnc/intouch.html
---------------------------------------------------------------------
