[cc +vfio-users] On Wed, 15 Aug 2018 20:14:29 +0200 Jes Urup <j...@urup.me> wrote:
> Yes i enabled that in /etc/default/grub cmdline. I have this: iommu=on > intel_iommu=on hugepages=1024 > When i run that command i get this: > https://paste.pound-python.org/show/8FrWghxbcz8qWYdAh8wl/ > > I want 0000:03:00.0 and 0000:04:00.0 which are intel nic's to use vfio-pci. > > I've also added all the configs to the kernel. > > When i run virt-manager i cannot see the device that ive set to use > vfio-pci driver. And i cannot find anything in dmesg. > I also have this: options vfio-pci ids=8086:10d3 in > /etc/modprobe.d/vfio.conf I don't understand what you're saying here, virt-manager doesn't care whether devices are initially bound to vfio-pci, "Add Hardware -> PCI Host Device" shows every PCI device in the system. If you pick 3:00.0 and 4:00.0, then libvirt will default to managed='yes' which means that libvirt will bind the device to vfio-pci for you when the VM is started and unbind when stopped. It's not absolutely necessary to pre-bind devices to vfio-pci, it's only recommended if you only plan to use the device with vfio-pci or for special cases like GPUs where host drivers don't always behave well with unbinding or put the device into a bad state. Setting an ids= option for vfio-pci only adds the ID to the vfio-pci driver, it will bind to devices matching that ID when it's loaded, but only if matching devices are not already bound to another driver. It won't cause the e1000e driver to release devices it has already claimed. Since you're using libvirt, you can also use: # virsh nodedev-detach pci_0000_03_00_0 # virsh nodedev-detach pci_0000_04_00_0 to bind the devices to vfio-pci. Thanks, Alex _______________________________________________ vfio-users mailing list vfio-users@redhat.com https://www.redhat.com/mailman/listinfo/vfio-users