Channels.conf (relevant part, i think) looks something like this MTV3;MTV Oy=Digita Finland:482:B8C23D23G8M64N3S0T8Y0:T:0:305=2:561=fin@4,562=dut@4:5010;1073=fin,1074=dut:0:49:8438:8193:0 Nelonen;Sanoma Television Oy=Digita Finland:482:B8C23D23G8M64N4S0T8Y0:T:0:512=2:650=fin@4,658=dut@4:5012:0:65:8438:8193:0 Sub;SubTV OY=Digita Finland:482:B8C23D23G8M64N6S0T8Y0:T:0:353=2:609=fin@4:5010:0:97:8438:8193:0 Liv;Sanoma Television Oy=Digita Finland:482:B8C23D23G8M64N8S0T8Y0:T:0:516=2:690=fin@4:5012:0:177:8438:8193:0 Jim;Sanoma Television OY:658000000:B8C23D23G8M64N9S0T8Y0:T:27500:522=2:720=fin@4:0:0:129:8438:20481:0 Kutonen;SBS Finland:658000000:B8C23D23G8M64N11S0T8Y0:T:27500:523=2:655=fin@4:0:0:178:8438:20481:0
All of these tune fine. However if I set UpdateChannels to 4 (new channels) or 5 (new transponders) after a couple of seconds it turns into this MTV3;MTV Oy=Digita Finland:658000000:B8C23D23G8M64N3S0T8Y0:T:0:305=2:561=fin@4,562=dut@4:5010;1073=fin,1074=dut:0:49:8438:8193:0 Nelonen;Sanoma Television Oy=Digita Finland:658000000:B8C23D23G8M64N4S0T8Y0:T:0:512=2:650=fin@4,658=dut@4:5012:0:65:8438:8193:0 Sub;SubTV OY=Digita Finland:658000000:B8C23D23G8M64N6S0T8Y0:T:0:353=2:609=fin@4:5010:0:97:8438:8193:0 Liv;Sanoma Television Oy=Digita Finland:658000000:B8C23D23G8M64N8S0T8Y0:T:0:516=2:690=fin@4:5012:0:177:8438:8193:0 Jim;Sanoma Television OY:658000000:B8C23D23G8M64N9S0T8Y0:T:27500:522=2:720=fin@4:0:0:129:8438:20481:0 Kutonen;SBS Finland:658000000:B8C23D23G8M64N11S0T8Y0:T:27500:523=2:655=fin@4:0:0:178:8438:20481:0 and obviously those channels at 482MHz no longer work. How is this useful and how do I make it stop? Keeping UpdateChannels at 3 has been my non-solution for some years now but it's getting annoying when channels seem to change their settings so infuriatingly often. _______________________________________________ vdr mailing list vdr@linuxtv.org http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
