On 20/12/2023 17:49, jmalo...@umass.edu wrote:
In the past when I collected data from the x410 without DPDK, it would
work just fine to use solely 1 network port.
I tried using the management address now, but I still get errors, but
it is slightly different. Notably there is not a “no chdr_connection
available” error.
|./benchmark_rate --rx_rate 491.52e6 --rx_channels 0 --tx_rate
491.52e6 --tx_channels 0 --args
"addr=192.168.10.2,mgmt_addr=192.168.1.254,use_dpdk=1"|
|[INFO] [UHD] linux; GNU C++ version 9.4.0; Boost_107100; DPDK_19.11;
UHD_4.5.0.main-2-ga7657c80|
|[WARNING] [PREFS] Loaded config from /root/.uhd. This location is
considered deprecated, consider moving your config file to
/root/.config instead.|
|EAL: Detected 32 lcore(s)|
|EAL: Detected 1 NUMA nodes|
|EAL: Multi-process socket /var/run/dpdk/rte/mp_socket|
|EAL: Selected IOVA mode 'PA'|
|EAL: No available hugepages reported in hugepages-1048576kB|
|EAL: Probing VFIO support...|
|EAL: VFIO support initialized|
|EAL: PCI device 0000:06:00.0 on NUMA socket -1|
|EAL: probe driver: 15b3:1017 net_mlx5|
|EAL: PCI device 0000:06:00.1 on NUMA socket -1|
|EAL: probe driver: 15b3:1017 net_mlx5|
|[ERROR] [DPDK] Could not find route to destination address 192.168.10.2|
|[ERROR] [X300] X300 Network discovery error RuntimeError: DPDK: Could
not find route to destination address 192.168.10.2|
|[00:00:00.000209] Creating the usrp device with:
addr=192.168.10.2,mgmt_addr=192.168.1.254,use_dpdk=1...|
|[ERROR] [DPDK] Could not find route to destination address 192.168.10.2|
|[ERROR] [X300] X300 Network discovery error RuntimeError: DPDK: Could
not find route to destination address 192.168.10.2|
|Error: LookupError: KeyError: No devices found for ----->|
|Device Address:|
|addr: 192.168.10.2|
|mgmt_addr: 192.168.1.254|
|use_dpdk: 1|
If you specify type=x4xx,product=x410 does this change things? What
about if you side-step DPDK just for testing? Does
that work?
_______________________________________________
USRP-users mailing list -- usrp-users@lists.ettus.com
To unsubscribe send an email to usrp-users-le...@lists.ettus.com
