Mohan2005 schrieb:
Hello Rainer
I am using mod_jk 1.2.25
And I assume val1 is the name of the node (NODE1 in this case)
No, val1 ist the value for the first member of the load balancer, val2
for the second and so on. So it is meant as is.
so I tried both
http://localhost/jkmanager/?cmd=update&mime=txt&w=TEST&att=wa&NODE1=activate
This won't work.
and
http://localhost/jkmanager/?cmd=update&mime=txt&w=TEST&att=wa&val1=activate
What's the difference betwen this, and what you get, when you do it via
the GUI? It is so much easier to get the right URL by simply doing it
once via the GUI.
But did not activate a stopped node. (NODE1 in this case)
Thanks you for your help and attention to this.
Regards
Mohan
Rainer
Rainer Jung-3 wrote:
Mohan2005 schrieb:
Hello Again;
I tried the following, did not take effect;
What am I doing wrong here please;
My jkmanager shows this for the Loadbalancer "TEST" and it has only one
node
called "NODE1"
Name Type Host Addr Act State D F M
V Acc Err CE RE Wr Rd Busy Max
Route
RR Cd Rs
[E|R] NODE1 ajp13 10.0.0.112:8109 10.0.0.112:8109 STP OK/IDLE 0
1 1 0 0
0 0
0 0 0 0 0 NODE1 WwwNODE1Com 0/0
Then I would call the following url to Activate the node.
http://localhost/jkmanager/?cmd=update&mime=txt&w=TEST&att=wa&NODE1=activate
Go to the esit page and do the same change via the GUI. After committing
the change in the GUI, there should be the correct URL in the browser
URL line for a couple of seconds, before the browser gets redirected to
the start page. The only parameter, which will be missing, is "mime",
which is not very important and will only format the OK message slightly
different, in case you want to evaluate it later in your script client.
You can also have a look at the form contents.
See below, for what I expect as a correct URL.
This would result in
Result: type=OK message="Action finished"
But the node does not get "activate"d.
Please advice.
Thanks and regards
Mohan
Rainer Jung-3 wrote:
Mladen Turk wrote:
Mohan2005 wrote:
Examples:
cmd=update
mime=txt
w=myloadbalancer
sw=memberofloadbalancer
wa=disabled
http://localhost/jkmanager/?cmd=update&mime=txt&w=TEST&sw=NODE1&wa=activate
Mass editing of one attribute for all sub workers (also called edit by
aspect) could be done via
cmd=update
mime=txt
w=myloadbalancer
att=wa
val1=disabled
val2=active
val3=disabled
val4=disabled
val5=active
http://localhost/jkmanager/?cmd=update&mime=txt&w=TEST&att=wa&val1=activate
Regards,
Rainer
---------------------------------------------------------------------
To start a new topic, e-mail: users@tomcat.apache.org
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]