On Sat, May 14, 2022 at 12:53 AM <[email protected]> wrote: > > I’ve tried your suggestion and continue to get the same results.
It will be more helpful if you describe in detail what you tried and what the results were. > Based on continuing investigation I’ve found on the Red Hat Knowledge base a > resolution to this issue, the following link references the solution: > https://access.redhat.com/solutions/354255. This URL does not exist. > However, I’ve run across another issue, since the creation of a new host > within ovirt Based on the output of "ovirt-imageio --show-config" you had an all-in-one setup, when the engine host is added to the engine as a hypervisor. This setup is not supported but works, but adding more hosts to this kind of setup will not work with image transfer, and it is a really bad idea to have multiple hosts and run engine on one of them. For example, engine can stop a host using host power management API. If this is the host running engine you don't have a way to start your engine unless you have access to the host power management console. If have more than one host, your engine should not run on any of the hosts, and you must enable the imageio proxy (this is the default): engine-config -s ImageTransferProxyEnabled=true And restart engine: systemctl restart ovirt-engine > I’ve not been able to access the internet or reach the host/server remotely. > Therefore, I’m unable to try the solution provide via the Red Hat Knowledge > Base. > > I’ve reviewed the kernel routing table displayed below: > > > ip route show > default via 20.10.20.1 dev eno5 proto static metric 100 > default via 20.10.20.1 dev eno6 proto static metric 101 > default via 20.10.20.1 dev eno7 proto static metric 102 > default via 20.10.20.1 dev ovirtmgmt proto static metric 425 > 20.10.20.0/24 dev eno5 proto kernel scope link src 20.10.20.65 metric 100 > 20.10.20.0/24 dev eno6 proto kernel scope link src 20.10.20.66 metric 101 > 20.10.20.0/24 dev eno7 proto kernel scope link src 20.10.20.67 metric 102 > 20.10.20.0/24 dev ovirtmgmt proto kernel scope link src 20.10.20.68 metric 425 > > Is it normal behavior for the host to sever all connection when a “Host” > machine is added to ovirt? Is there a solution to this issue? I’ve > recognize the risks of having the host exposed to the internet, how would I > keep the OS/RHEL 8.6 & ovirt current? It is hard to tell what's going on when we don't know which hosts do you have and what is their ip address. Please confirm that you access engine using https:// and that when you access the host your browser reports a secure connection without warnings (meaning that engine CA certificate was added to the browser). Nir _______________________________________________ Users mailing list -- [email protected] To unsubscribe send an email to [email protected] Privacy Statement: https://www.ovirt.org/privacy-policy.html oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/[email protected]/message/22WGHAU3NHVB256S6UYT2F7G7VQZWAMG/
