You can use either LACP or balance round-robin. Of course it is very important
to know if your clients will be behind a single IP (for example behind
router).As most of the bonding hash policy depend on either MAC (L2) or IP +
Port (L3) , you will have a hard time to load balance to clients with the same
IP.
In my case, I have a team device with 6 x 1GbE ports.As my setup is
hyperconverged (replica 3 arbiter 1) , I had to use multiple gluster volumes
(and each brick has different port) with 1 VM disk per volume and to stripe on
VM level for better performance.
Best Regards,Strahil Nikolov
В сряда, 24 юли 2019 г., 11:02:48 ч. Гринуич+3, Edoardo Mazza
<[email protected]> написа:
Hello everyone,I need to create a bond for vm interfaces but I don't kown what
is the best solution, you can help
me?ThanksEdoardo_______________________________________________
Users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
Privacy Statement: https://www.ovirt.org/site/privacy-policy/
oVirt Code of Conduct:
https://www.ovirt.org/community/about/community-guidelines/
List Archives:
https://lists.ovirt.org/archives/list/[email protected]/message/TFLL6M32PLES3H4G6U5Y67KCYMZRXGOH/
_______________________________________________
Users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
Privacy Statement: https://www.ovirt.org/site/privacy-policy/
oVirt Code of Conduct:
https://www.ovirt.org/community/about/community-guidelines/
List Archives:
https://lists.ovirt.org/archives/list/[email protected]/message/QEPDABQM4IGW7K5D63NRSVLHAA4NWVRM/
