On Fri, Jun 15, 2018 at 12:13 PM, <[email protected]> wrote: > I have successfully got glusterfs playbook to finish once and then my > networking was wrong on the managed engine and on the hosts, so I started > over. > > > > Now I can’t seem to even get that far again. I completely reloaded the > hosts, but that takes a while. Last time glusterfs failed right at the end > with > > "host is not in 'Peer in Cluster' state" > > > > Redeploying fails as partitions already exist… > > > > I am deploying to /dev/sdb > > > > Is there a quick way to get /dev/sdb back into a state to redeploy to? I > think I got there once by doing pvremove and gdisk zap gpt, but not sure if > that worked or caused problem on the redeploy. >
You should be able to remove the vg using vgremove (use vgs to determine which one ) and pvremove /dev/sdb to reuse it. > > Its very time consuming to start over from scratch, so would appreciate if > there is any shortcut instead of reloading the OS. > > > > Thans > > Bill > > > > _______________________________________________ > Users mailing list -- [email protected] > To unsubscribe send an email to [email protected] > Privacy Statement: https://www.ovirt.org/site/privacy-policy/ > oVirt Code of Conduct: https://www.ovirt.org/community/about/community- > guidelines/ > List Archives: https://lists.ovirt.org/archives/list/[email protected]/ > message/UXKTR6VE7YP5MPJ3FPTBLSMUKWN3GKZA/ > >
_______________________________________________ Users mailing list -- [email protected] To unsubscribe send an email to [email protected] Privacy Statement: https://www.ovirt.org/site/privacy-policy/ oVirt Code of Conduct: https://www.ovirt.org/community/about/community-guidelines/ List Archives: https://lists.ovirt.org/archives/list/[email protected]/message/LZVWVNUF3QQZKC5MNAFGIOWEZJZZWOIZ/
