Hi Hanson,
Thank you for your answer, but the routeur is a VM.
So I need that this VM start without the engine. It has to start when
the node start (after a power failure).
Only when the routeur will be up, I will be able to manage the node and
the VMs.
Do you think there a solution ?
Sincerely,
Fabrice
Le 26/02/2018 à 18:18, Hanson Turner a écrit :
Hi Fabrice,
If there's an issue with the hypervisor, the VM should pause. In the
highly available section, (edit the advanced options on the vm) you
can set the resume options.... restart/resume/stay off
The engine needs to be able to see + manage the node. You'll have to
take care of the networking/port forwarding/vpn/vlan etc to make sure
the engine can control the node.
Once the node's in control, the engine can restore the VM when it
knows the node is good.
Thanks,
Hanson
On 02/26/2018 04:09 PM, Fabrice SOLER wrote:
Hello,
My node (IP ovirtmgmt) is behind a routeur that is running on the
hypervisor (the node itself).
So, I need that the VM (routeur) start automatically after the node
start.
The ovirt engine is running on another infrastructure and the version
is 4.2.0. The node is also in this version.
Is there a solution ?
Sincerely,
--
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
[email protected]
http://lists.ovirt.org/mailman/listinfo/users
