Yes, you're right. # The following are used only for iSCSI storage iqn= portal= user= password= port=
Simone, what do you think, will it be possible to add targets in hosted-engine.conf as a workaround? On Wed, Feb 3, 2016 at 2:46 PM, gflwqs gflwqs <[email protected]> wrote: > Yes but i have to change the config for the HE in > /etc/ovirt-hosted-engine/hosted-engine.conf so how should that look like? > There is only one variable for storage and since there is dual pathing > there is 2 ip:s so is there some other config for multipathing? > > storage=x.x.x.x > > 2016-02-03 13:17 GMT+01:00 Elad Ben Aharon <[email protected]>: > >> The scenario of manually connecting the hosted-engine host to several >> paths wasn't tested before, but by theory it should work. >> As you said, the host should be set to global maintenance, disconnected >> from the single iSCSI session [1] and reconnected to the dual paths [2]. >> Then host re-activation. >> >> [1] # iscsiadm -m session -u >> # iscsiadm -m node -o delete >> [2] # iscsiadm -m discovery -t sendtargets -p target_IP:port >> # iscsiadm -m node target_name -l >> >> On Wed, Feb 3, 2016 at 12:12 PM, gflwqs gflwqs <[email protected]> wrote: >> >>> So does that mean i can change it if i put the HE into global >>> maintenance and restart it? >>> If that is possible then it is ok for me? >>> >>> /Christian >>> >>> 2016-02-03 11:07 GMT+01:00 Elad Ben Aharon <[email protected]>: >>> >>>> Hi, >>>> >>>> Deployment over more than one path is currently not supported. There is >>>> a request for it: https://bugzilla.redhat.com/show_bug.cgi?id=1193961 >>>> I can't think of a way for manually change to dual paths and keep the >>>> VM running without interruptions. >>>> >>>> Adding Simone and Nir who might have an idea. >>>> >>>> >>>> On Wed, Feb 3, 2016 at 10:37 AM, gflwqs gflwqs <[email protected]> >>>> wrote: >>>> >>>>> Hi List, >>>>> >>>>> I have installed the hosted engine over iscsi but have a problem >>>>> getting it to install over the multipath, even though i can see the >>>>> multipath device from the host with multipath -ll. >>>>> >>>>> When i get to the point in the HE installer where i should choose the >>>>> disk i only see the underlying devices like sdb sdc. So if i choose one of >>>>> those it results in that it will only use one of the paths! >>>>> >>>>> My questions is: >>>>> - Is there a bug in the installer script or am i doing something wrong? >>>>> - I now have a running HE and would like to manually change the single >>>>> path to dual, how do i accomplish this? >>>>> >>>>> I am running ovirt 3.5.6.2. >>>>> >>>>> Regards >>>>> Christian >>>>> >>>>> >>>>> >>>>> _______________________________________________ >>>>> Users mailing list >>>>> [email protected] >>>>> http://lists.ovirt.org/mailman/listinfo/users >>>>> >>>>> >>>> >>> >> >
_______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
