That's what I did, but didn't work for me. 1. use the 192.168.x interface to setup gluster. I used hostname in /etc/hosts.2. setup oVirt using the switched network hostnames, let's say 10.10.10.x3. oVirt and all that comes up fine.4. When try to create a storage domain, it only shows the 10.10.10.x hostnames available.
Tried to add a brick and I would get something like Host gfs2 is not in 'Peer in Cluster' state (while node2 is the hostname and gfs2 is the 192.168 name) Ran command `gluster probe peer gfs2` or `gluster probe peer 192.168.x.x` didn't work peer probe: failed: Probe returned with unknown errno 107 Ran probe again with the switched network hostname or IP worked fine. May be it is not possible with current GlusterFS version? http://www.gluster.org/community/documentation/index.php/Features/SplitNetwork Will On Thursday, January 8, 2015 3:43 AM, Sahina Bose <[email protected]> wrote: On 01/08/2015 12:07 AM, Will K wrote: Hi I would like to see if anyone has good suggestion. I have two physical hosts with 1GB connections to switched networks. The hosts also have 10GB interface connected directly using Twinax cable like copper crossover cable. The idea was to use the 10GB as a "private network" for GlusterFS till the day we want to grow out of this 2 node setup. GlusterFS was setup with the 10GB ports using non-routable IPs and hostnames in /etc/hosts, for example, gfs1 192.168.1.1 and gfs2 192.168.1.2. I'm following example from community.redhat.com/blog/2014/10/up-and-running-with-ovirt-3-5/ , Currently I'm only using Gluster volume on node1, but `gluster probe peer` test worked fine with node2 through the 10GB connection. oVirt engine was setup on physical host1 with hosted engine. Now, when I try to create new Gluster storage domain, I can only see the host "node1" available. Is there anyway I can setup oVirt on node1 and node2, while using "gfs1" and "gfs2" for GlusterFS? or some way to take advantage of the 10GB connection? If I understand right, you have 2 interfaces on each of your hosts, and you want oVirt to communicate via 1 interface and glusterfs to use other? While adding the hosts to oVirt you could use ip1 and then.while creating the volume, add the brick using the other ip address. For instance, gluster volume create <volname> 192.168.1.2:/bricks/b1 Currently, there's no way to specify the IP address to use while adding a brick from oVirt UI (we're working on this for 3.6), but you could do this from the gluster CLI commands. This would then be detected in the oVirt UI. Thanks W _______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________ Users mailing list [email protected] http://lists.ovirt.org/mailman/listinfo/users
