if forced build works fine, scheduled build should work too because it's the same code that run both. The possible difference is if you have more than one build definition, the forced build use the
default one.
About logs, you must have the same log for scheduled and forced builds. I don't
understand what's happen.
Emmanuel
Anshula a écrit :
I dont think so. When I installed Continuum, I followed the standard
installation instructions. I havent changed the logging configurations
anywhere.
These logs are for 1 day only. Continuum is running as a service and I have
scheduled a build at 7:30 pm. Usually what I observe is that the logs get
written at 7:30 pm when Continuum starts to checkout source and build the
files.
I am attaching one more file from a previo
http://www.nabble.com/file/p12522974/wrapper.20070829.log
wrapper.20070829.log us day as well, which has logs of some forced builds as
well.
Thanks
Anshula
Emmanuel Venisse wrote:
Do you have redefined log levels? I don't see lot of logs in the file you
sent.
Anshula a écrit :
Emmanuel,
In the build-output-directory of each project as well as on the build
result
page, the last build that I can find is the last successful build.
The Builds that have a timeout, did not generate a build result.
The only place that it logged about the timeout was the Continuum log
file/Wrapper.log.
Should it have generated a build result ? Coz it did not get built at
all...
Thanks,
Anshula
Emmanuel Venisse wrote:
In build result page, choose a build result with timeout ant take the
build id, then go to the build-output-directory and send us the content
of
the build output you'll find in this directory.
Emmanuel
Anshula a écrit :
Hi Emmanuel,
The File is as attached. Thanks for the help.
Anshula
Emmanuel Venisse wrote:
Can you send your logs?
Anshula a écrit :
Hi Emmanuel,
Acutally right now I am just building, there are no unit tests added
as
of
now. The build does not take more than 1-2 minutes, I tried building
all
projects locally and verified this.
Regards,
Anshula
Emmanuel Venisse wrote:
Maybe you have a test that hang out?
Emmanuel
Anshula a écrit :
Hello all,
I am using Continuum 1.1-beta-2 with Perforce to integrate all my
projects
in the build management system.
I have been using it over a month or so, and have around 15 project
groups/projects integrated into it. I have scheduled a build in the
system
which runs at 7:30 pm everyday.
The build system has been running properly building when it detects
changes
at the scheduled time
But since 2 days, everyday the builds are timing out. I have set a
Maximum
job execution time of 3600 secs. Each of the projects does not take
more
than 1 minute to build.
Continuum queues all the projects and prints a warning in the log
file
like
-
"Task
[EMAIL PROTECTED]
didn't
complete within time, cancelling it." And shows all the projects in
queued
state only. I need to restart Continuum to build them again.
Thanks for your time. Any help will be appreciated.
Regards,
Anshula
http://www.nabble.com/file/p12500482/wrapper.20070901.log
wrapper.20070901.log
