Although I don't really know what I'm talking about, I would be looking
at the <baseDirectory> tag in the assembly descriptor if I was you.
Later,
Andy
-------------
Yada, yada, yada...
The information contained in this e-mail (including any attachments) is
confidential and is intended for the use of the addressee only. The
opinions expressed within this e-mail (including any attachments) are
the opinions of the sender and do not necessarily constitute those of
Roslin Institute (Edinburgh) ("the Institute") unless specifically
stated by a sender who is duly authorised to do so on behalf of the
Institute.
> -----Original Message-----
> From: Dave Hoffer [mailto:[EMAIL PROTECTED]
> Sent: 09 January 2007 17:17
> To: [email protected]
> Subject: Can the assembly plugin output to file share?
>
> Is it possible to configure the assembly plugin to put the
> final output on a network share?
>
> <binaries>
> <outputDirectory>\\server\share\folder</outputDirectory>
> <includeDependencies>true</includeDependencies>
> <unpack>false</unpack>
> </binaries>
>
> For example, when I do the above it puts the output relative
> to target instead of treating this as a full path. Is there
> a way to make it treat this as a full path?
>
> -dh
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED]
> For additional commands, e-mail: [EMAIL PROTECTED]
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
