Gerard,
Perhaps you have cvs.exe in user's path, not in system? I would recommed
you to put it to system variables.
Best regards,
Juri.
-----Original Message-----
From: Gerard Garrigan [mailto:[EMAIL PROTECTED]
Sent: Tuesday, May 23, 2006 6:47 PM
To: [email protected]
Subject: RE: Build Error
Juri,
If I run the cvs command from cmd there are no problems. I have the
cvs.exe specified in the PATH. However is there special path settings
for Continuum?
Thanks for your reply,
Ger
-----Original Message-----
From: Artamonov, Juri [mailto:[EMAIL PROTECTED]
Sent: 23 May 2006 16:44
To: [email protected]
Subject: RE: Build Error
Please verify your path environment variable. Cvs.exe file should be in
the "path". I belive if you start cvs.exe command from cmd on the
servers where continuum is running you will get the same message.
-----Original Message-----
From: Gerard Garrigan [mailto:[EMAIL PROTECTED]
Sent: Tuesday, May 23, 2006 6:30 PM
To: [email protected]
Subject: Build Error
Hello,
I've set up Continuum and everything seems to be fine but when I try to
build a project I get the following error:
************************************************************************
****
Build Error:
************************************************************************
****
Provider message: The cvs command failed.
Command output:
------------------------------------------------------------------------
-------
'cvs' is not recognized as an internal or external command, operable
program or batch file.
------------------------------------------------------------------------
-------
Any help on this is greatly appreciated,
Thanks very much,
Ger
Ger Garrigan
Software Engineer
Castlewood House, Castlewood Ave,
Rathmines, Dublin 6, Ireland.
Tel: +353 1 4060738 Fax: +353 1 4060748
<http://www.precisionsoftware.com/> www.precisionsoftware.com
