I'm working with a cluster that has both CPUs and GPUs, and I'm trying
to run the High Performance Linpack benchmark on it. Before I can do a
full system run, I have to figure out how to get the benchmark to run on
both GPUs and CPUs at the same time. I have HPL working fine with
openmpi using multiple nodes, but now I'm trying to use it on our system
with multiple nodes with CPUs and GPUs.
On 12/12/2011 02:49 PM, Andreas Schäfer wrote:
Hi Erin,
uhm, I don't think this is related to MPI as MPI is completely
orthogonal to GPU programming. MPI doesn't even know about GPUs. Just
select the GPU like you weren't using MPI at all.
HTH
-Andreas
On 14:44 Mon 12 Dec , Erin Rasmussen wrote:
I have multiple GPUs on a node in my cluster and am trying to run some
benchmarks on the system. However, since my department is in research
and has a job system set up, I can only take one GPU offline to test
until I are sure I know what I are doing. My problem is trying to set up
the mpirun command to specify a single GPU. I understand how to use
mpirun to run programs on specific processors on different nodes, but
the GPUs show up as devices and not processors. How do I set up my
mpirun command to use a specific GPU, or is that even possible?
_______________________________________________
users mailing list
us...@open-mpi.org
http://www.open-mpi.org/mailman/listinfo.cgi/users
_______________________________________________
users mailing list
us...@open-mpi.org
http://www.open-mpi.org/mailman/listinfo.cgi/users
