Hi I get the same error while linking against home built 1.5.4 openmpi libs on win32. I didn't get this error against the prebuilt libs.
I see you use Suse. There probably is a openmpi.rpm or openmpi.dpkg already available for Suse which contains the libraries and you could link against those and that may work MM -----Original Message----- From: users-boun...@open-mpi.org [mailto:users-boun...@open-mpi.org] On Behalf Of Markus Stiller Sent: 24 November 2011 20:41 To: us...@open-mpi.org Subject: [OMPI users] open-mpi error Hello, i have some problem with mpi, i looked in the FAQ and google already but i couldnt find a solution. To build mpi i used this: shell$ ./configure --prefix=/opt/mpirun <...lots of output...> shell$ make all install Worked fine so far. I am using dlpoly, and this makefile: $(MAKE) LD="mpif90 -o" LDFLAGS="-O3" \ FC="mpif90 -c" FCFLAGS="-O3" \ EX=$(EX) BINROOT=$(BINROOT) $(TYPE) This worked fine too, the problem occurs when i want to run a job with mpiexec -n 4 ./DLPOLY.Z or mpirun -n 4 ./DLPOLY.z I get this error: -------------------------------------------------------------------------- [linux-6wa6:02927] [[INVALID],INVALID] ORTE_ERROR_LOG: Not found in file orterun.c at line 543 markus@linux-6wa6:/media/808CCB178CCB069E/MD Simulations/Test Simu1> sudo mpiexec -n 4 ./DLPOLY.Z [linux-6wa6:03731] [[INVALID],INVALID] ORTE_ERROR_LOG: Not found in file runtime/orte_init.c at line 125 -------------------------------------------------------------------------- It looks like orte_init failed for some reason; your parallel process is likely to abort. There are many reasons that a parallel process can fail during orte_init; some of which are due to configuration or environment problems. This failure appears to be an internal failure; here's some additional information (which may only be relevant to an Open MPI developer): orte_ess_base_select failed --> Returned value Not found (-13) instead of ORTE_SUCCESS -------------------------------------------------------------------------- [linux-6wa6:03731] [[INVALID],INVALID] ORTE_ERROR_LOG: Not found in file orterun.c at line 543 Some Informations: I use Open MPI 1.4.4, Suse 64bit, AMD quadcore make check gives: make: *** No rule to make target `check'. Stop. I attached the ompi_info. Thx alot for your help, regards, Markus
