Well, yes these nodes do have multiple TCP interfaces.
I'll give 1.0.2 a whirl :)
Thanks!
Jeff
Do you, perchance, have multiple TCP interfaces on at least one of the
nodes you're running on?
We had a mistake in the TCP network matching code during startup -- this
is fixed in v1.0.2. Can you give that a whirl?
-----Original Message-----
From: users-boun...@open-mpi.org
[mailto:users-boun...@open-mpi.org] On Behalf Of Jeffrey B. Layton
Sent: Tuesday, April 11, 2006 11:25 AM
To: Open MPI Users
Subject: [OMPI users] Problem running code with OpenMPI-1.0.1
Good morning,
I'm trying to run one of the NAS Parallel Benchmarks (bt) with
OpenMPI-1.0.1 that was built with PGI 6.0. The code never
starts (at least I don't see any output) until I kill the code. Then
I get the following message:
[0,1,2][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_complete_connect]
connect() failed with
errno=113[0,1,4][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_c
omplete_connect]
connect() failed with
errno=113[0,1,8][btl_tcp_endpoint.c:559:mca_btl_tcp_endpoint_c
omplete_connect]
connect() failed with errno=113mpirun: killing job...
Any ideas on this one?
Thanks!
Jeff
_______________________________________________
users mailing list
us...@open-mpi.org
http://www.open-mpi.org/mailman/listinfo.cgi/users
_______________________________________________
users mailing list
us...@open-mpi.org
http://www.open-mpi.org/mailman/listinfo.cgi/users
