Hi, I think you can set up a tag the first time it happens, so it is not executed if the tag is present. Add a condition to evaluate if "configured" tag is present. If it is not: Configure and Tag, if it is: dont.
Kind regards, Miguel ----- Original Message ----- From: "Jose Vela Delgado" <[email protected]> To: "Community support for GenieACS users" <[email protected]> Sent: Tuesday, 21 February, 2017 2:48:16 PM Subject: Push file with Presets Hello friends. I would like to ask you how to properly configure a Preset to automatically put a configuration file in a CPE. As I currently have (with event 1 BOOT) works perfectly, but it goes into a loop, I explain: 1 The CPE is restarted, so the 1 BOOT event appears and the configuration file is perfectly downloaded. 2º Upon receiving the configuration file, it is restarted and, consequently, the 1 BOOT event reappears. 3º The BOOT event is restarted again and, consequently, the configuration file is unloaded and, therefore, it is restarted again. 4º ... and so on to infinity. Does anyone have it correctly set up so they do not make that loop? Greetings and I await your comments, Jose Vela Técnico de Networking Routing y Switching. Mira mi perfil profesional y conecta conmigo en LinkedIn pinchando en este enlace. _______________________________________________ Users mailing list [email protected] http://lists.genieacs.com/mailman/listinfo/users
_______________________________________________ Users mailing list [email protected] http://lists.genieacs.com/mailman/listinfo/users
