What does the syslog on the cpe contain? That will likely contain info on why the cpe is faulting. Did you change the parameters and restart the cwmp process?
-dan > On May 31, 2015, at 11:53 PM, Fabien Bazille <[email protected]> wrote: > > Thank you Manny, > > Dan, here is the log: > 00000C-CISCO887%252dK9V01-FCZ154390G7: Inform (1 BOOT); retry > count 0 > > 00000C-CISCO887%252dK9V01-FCZ154390G7: Started task > refreshObject(556c0ec04de397db3655201c) > > 00000C-CISCO887%252dK9V01-FCZ154390G7: Fault response for task > 556c0ec04de397db3655201c. Retrying after 300 seconds. > > And the Fault tells me resource exceeded. > > > > 2015-05-29 18:25 GMT+02:00 Manny Veloso <[email protected]>: >> That error is probably the Cisco CWMP client barfing. Some CWMP clients run >> out of memory when dumping their whole tr-98/181 tree, especially the older >> ones. >> >> The good thing is it tells you it’s dead, instead of just, well, dying. The >> below parameters should help. >> -- >> Manny Veloso >> Sr. Solutions Engineer >> Smartrg.com >> >> From: Dan Morphis <[email protected]> >> Reply-To: Community support for GenieACS users <[email protected]> >> Date: Friday, May 29, 2015 at 8:55 AM >> To: Community support for GenieACS users <[email protected]> >> Subject: Re: Cisco's CPE resources exceeded >> >> Fabien, >> Without seeing a log, I can only speculate that the connection is timing >> out. >> >> Try adjusting the GET_PARAMETER_NAMES_DEPTH_THRESHOLD and SESSION_TIMEOUT >> values. The wiki has >> information on more information on the values to try. Remember to restart >> the cwmp worker after adjusting the values. >> >> In my environment, I had to use >> "GET_PARAMETER_NAMES_DEPTH_THRESHOLD" : 2, >> "SESSION_TIMEOUT" : 90, >> >> -dan >> >>> On Fri, May 29, 2015 at 12:04 AM, Fabien Bazille <[email protected]> >>> wrote: >>> Hi, >>> >>> I'm trying to add some Cisco routers in my network pro supervision and >>> provision. >>> After i start the cwmp on the cisco, the device is correctly added to >>> GenieACS, but for the task: RefreshObject i get a resources exceeded fault >>> code (9004). >>> And when i look to a capture the frame causing that problem is the >>> GetParameterValues from the ACS. >>> >>> My training concern the setup of GenieACS, that's why i open so much issues >>> and I'm sorry for that. >>> >>> Thank you for your time. >>> >>> Best regards, >>> >>> Fabien B >>> >>> _______________________________________________ >>> Users mailing list >>> [email protected] >>> http://lists.genieacs.com/mailman/listinfo/users >> >> >> _______________________________________________ >> Users mailing list >> [email protected] >> http://lists.genieacs.com/mailman/listinfo/users > > _______________________________________________ > Users mailing list > [email protected] > http://lists.genieacs.com/mailman/listinfo/users
_______________________________________________ Users mailing list [email protected] http://lists.genieacs.com/mailman/listinfo/users
