I think what you have is dhcp on your router but the interface ip on the router
does not change when you change the ip... So when you try to reach it after the
change you can't.
I would suggest you do
Netstat -nr
Which should show the ip and default gateway ...
Try this then change the server again ..
Traceroute would also show you what the next hop is ...
Oluwagbenga Shobowale
-----Original Message-----
From: Timothy Murphy <gayle...@eircom.net>
Sender: users-boun...@lists.fedoraproject.org
Date: Fri, 11 May 2012 16:25:12
To: <users@lists.fedoraproject.org>
Reply-To: gayle...@eircom.net,
Community support for Fedora users <users@lists.fedoraproject.org>
Subject: Re: Network problems
Olav Vitters wrote:
> On Fri, May 11, 2012 at 12:44:16PM +0100, Timothy Murphy wrote:
>> I couldn't find a clear account of the effect of the line
>> anywhere in the shorewall documentation.
>
> Add it, apply the changes and run the following as root:
> iptables -t nat -L -n
>
> That'll tell you what it does.
I did do that:
----------------------------------
[tim@grover two-interfaces]$ sudo iptables -t nat -L -n
Chain PREROUTING (policy ACCEPT)
target prot opt source destination
dnat all -- 0.0.0.0/0 0.0.0.0/0
Chain POSTROUTING (policy ACCEPT)
target prot opt source destination
eth0_masq all -- 0.0.0.0/0 0.0.0.0/0
Chain OUTPUT (policy ACCEPT)
target prot opt source destination
Chain dnat (1 references)
target prot opt source destination
net_dnat all -- 0.0.0.0/0 0.0.0.0/0
Chain eth0_masq (1 references)
target prot opt source destination
MASQUERADE all -- 192.168.2.0/24 0.0.0.0/0
----------------------------------
I don't find this very clear.
I take it that it supports what I said, namely
==================================
-------------------------------
I have the lines
#INTERFACE SOURCE ADDRESS PROTO PORT(S) IPSEC MARK
eth0 eth1
in /etc/shorewall/masq on my server.
-------------------------------
My question is: what exactly is the effect of this?
Does IP masquerading by default only apply
to the firewall server to modem interface (eth0 in my case)?
And does the above line mean that it will also be applied
to packets reaching the firewall server on the eth1 LAN?
==================================
If I was right, wouldn't it have been simpler just to say,
"Yes, you are right"?
--
Timothy Murphy
e-mail: gayleard /at/ eircom.net
tel: +353-86-2336090, +353-1-2842366
s-mail: School of Mathematics, Trinity College Dublin
--
users mailing list
users@lists.fedoraproject.org
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
--
users mailing list
users@lists.fedoraproject.org
To unsubscribe or change subscription options:
https://admin.fedoraproject.org/mailman/listinfo/users
Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
Have a question? Ask away: http://ask.fedoraproject.org
