Thanks, I knew this, but doesnt work. However I have insterted successfully the b43 driver, but somehow gets disabled my wireless network. I think this is causing by NetworkManager, but couldn't tell that why. Maybe I don't have right, but currently I'm stucked with an disabled Broadcom-PHY. Well, it seems in dmesg that first turns on the PHY then turns off???
Here is my part of the dmesg: sky2 0000:02:00.0: eth0: enabling interface ADDRCONF(NETDEV_UP): eth0: link is not ready b43 ssb0:0: firmware: requesting b43/ucode15.fw b43 ssb0:0: firmware: requesting b43/lp0initvals15.fw b43 ssb0:0: firmware: requesting b43/lp0bsinitvals15.fw b43-phy0: Loading firmware version 478.104 (2008-07-01 00:50:23) ADDRCONF(NETDEV_UP): wlan0: link is not ready sky2 0000:02:00.0: eth0: Link is up at 100 Mbps, full duplex, flow control both ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Bluetooth: L2CAP ver 2.14 Bluetooth: L2CAP socket layer initialized Bluetooth: BNEP (Ethernet Emulation) ver 1.3 Bluetooth: BNEP filters: protocol multicast Bridge firewalling registered Bluetooth: SCO (Voice Link) ver 0.6 Bluetooth: SCO socket layer initialized Bluetooth: RFCOMM TTY layer initialized Bluetooth: RFCOMM socket layer initialized Bluetooth: RFCOMM ver 1.11 hda-intel: IRQ timing workaround is activated for card #1. Suggest a bigger bdl_pos_adj. b43-phy0: Radio hardware status changed to DISABLED Furthermore, on networkmanager gui where you could turn off/on the networks (right click on upper systray icon), greyed out - so couldn't explain what happened... PS: If I would like to always load an module for my computer, where must I note that for the system? (HP WMI driver module) 2010/9/4 Athmane Madjoudj <athma...@gmail.com> > On 09/04/2010 09:24 PM, Zoltan Hoppar wrote: > > Hi Everyone, > > > > I have a little problems with my new laptop HP Probook 4515s with Fedora > > 13, and the latest kernel. > > > > 1. Somehow, I couldn't activate the broadcom PHY - wifi module, I have > > followed many advices - linuxwireless.org <http://linuxwireless.org> and > > after many tries I have given up. In result I got only an broken network > > manager. > > Try the following: > > 1. Enable RPMFusion repo (both free and non-free). [1] > 2. as root: > # yum install kmod-wl broadcom-wl > > [1] http://rpmfusion.org/Configuration > > HTH > > [... SNIP ...] > > > -- > Athmane Madjoudj > -- > users mailing list > users@lists.fedoraproject.org > To unsubscribe or change subscription options: > https://admin.fedoraproject.org/mailman/listinfo/users > Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines > -- PGP: 06853DF7
-- users mailing list users@lists.fedoraproject.org To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
