Hi Steven, On Fri, May 28, 2010 at 16:59, Steven P. Ulrick <lists-fed...@afolkey2.net>wrote:
> Hello Everyone, > If the output of "/sbin/lspci | grep VGA" is: > 03:00.0 VGA compatible controller: nVidia Corporation G94 [GeForce 9600 GT] > (rev > a1) > > are the correct instructions for installing the proprietary NVidia driver > still > located here: > http://fedorasolved.org/video-solutions/nvidia-yum-kmod > > I have tried the above referenced instructions a couple of times, with the > same, > bad results... I am now going to try again, paying special attention to > the > "Troubleshooting" section... With this exact system, I have been so used > to > everything working (up until I installed Fedora 13) that I have never even > had > to look at the troubleshooting steps for these instructions before. > > I will get back to you with whatever happens. > I have a 9800 GT, and all I had to do for F13 was enable rpmfusion repo and install kmod-nvidia; after that Nvidia driver was already used on the next boot, but it didn't recognize my dual-head setup (which was expected). I tried using nvidia-settings (as root) to configure dual-head, but I had some trouble setting it exactly the way I wanted; then I just replaced /etc/X11/xorg.conf with the one from my F12 /etc backup and that was it. Much easier than with F12 =) HTH Andre
-- users mailing list users@lists.fedoraproject.org To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
