Hi, Only one bearerbox is running, attempting to start another using the same config fails....
Regards On Mon, Oct 15, 2012 at 3:38 PM, spameden <[email protected]> wrote: > Can you check in processlist if there is multiple bearerbox instances > running? > > with command: > ps auxww|grep bearerbox > > > 2012/10/15 Eric Beda <[email protected]> > >> Hi, >> >> Well I only have one group=smsc connection which is configured to act as >> a transceiver >> >> Regards >> >> >> On Mon, Oct 15, 2012 at 3:34 PM, spameden <[email protected]> wrote: >> >>> You probably have multiple >>> >>> group=smsc >>> >>> defined inside your kannel.conf >>> >>> >>> 2012/10/15 Eric Beda <[email protected]> >>> >>>> Hi all, >>>> >>>> I have come up with an unfortunate problem. I had a working kannel >>>> configuration with an operators SMSC, everything was working fine, then >>>> lately they say that I am connecting to there interface using two >>>> interfaces. They have now limited me to one, and my kannel logs receive an >>>> error >>>> >>>> SMSC rejected login to receive code 0x0000000d (bind failed) >>>> >>>> I have configured kannel as a transceiver via transceiver-mode=true. I >>>> have asked them to undue the interface limit whilst I re-configure my >>>> setup. >>>> >>>> I checked out the connections to my server via lsof -i .... I noticed >>>> is that bearerbox under transceiver-mode initiates two connections to SMSC, >>>> which I suspect the mobile operator treats as two interfaces. So my >>>> question is how do I get kannel to connect to SMSC via one TCP connection >>>> in transceiver mode >>>> >>>> Hope will get help >>>> >>>> Regards >>>> >>> >>> >> >
