Hi,
Best starting point would be to read the User's Guide from the site. It has
a section dedicated to modem initialization. If after trying it out you
still have specific questions, please address this list and post maximum
detail relevant logs + configuration.
In the meantime using a serial communication program like minicom, type the
following commands to the modem:
AT+CMGF=?
AT+CMGF?
And post output.
BR,
Nikos
----- Original Message -----
From: "Mailing Lists" <[email protected]>
To: <[email protected]>
Sent: Thursday, July 22, 2010 5:11 AM
Subject: kannel 1.4.3 -> multitech mtcba-c-n2, serial -> sprint cdma
...modem error trying to open
Hi ... am new to Kannel and the board. Looking to setup a sms gateway
using a multitech mtcba-c-n2 over Sprint CDMA. am running on the latest
release of Debian, 32bit.
am able to communicate to the modem and send text messages via putty
communicating through the serial port (ttyS0).
when bearerbox starts, it sees the modem, sends the init string no problem
(set to auto - it picks it up as a wavecom) but spits out an error when
bearerbox pushes an AT+CMGF=0^M, then restarts the sequence. the multitech
AT command reference DOES NOT have this command listed and manually trying
it in putty spits out an error too - my modem does not accept this it
seems!
before this I was having a problem with the +CPIN command till I set the
no-pin = true in modems.conf. being CDMA, I do not have a pin.
I'm wondering:
1. if Kannel is compatible with AT CDMA modems and mine in particular?
2. what file do I need to edit to customize the AT commands Kannel sends
to my modem? (if possible)
thanks a bunch ~Rich
--
Mailing Lists <[email protected]>
