Normally your cluster would have some PEs (parallel environments) set up.
Common ones are “smp” or “make”. You can use qconf –spl to list the ones
configured on your cluster.
A common commandline pattern for us is specifying cores like:
qsub –pe smp 6
Best,
Chris
On 1/5/17, 1:14 PM, "users-boun...@gridengine.org on behalf of Jin Li"
<users-boun...@gridengine.org on behalf of lijin....@gmail.com> wrote:
Hi all,
I have one multiple thread program using 6 threads. I want to submit
this program to a queue ( where the host has more than 6 cores). What
is the option I need to specify for the core number when submitting
the job to the queue? Thanks for your help.
Best regards,
Jin
_______________________________________________
users mailing list
users@gridengine.org
https://gridengine.org/mailman/listinfo/users
This electronic message is intended for the use of the named recipient only,
and may contain information that is confidential, privileged or protected from
disclosure under applicable law. If you are not the intended recipient, or an
employee or agent responsible for delivering this message to the intended
recipient, you are hereby notified that any reading, disclosure, dissemination,
distribution, copying or use of the contents of this message including any of
its attachments is strictly prohibited. If you have received this message in
error or are not the named recipient, please notify us immediately by
contacting the sender at the electronic mail address noted above, and destroy
all copies of this message. Please note, the recipient should check this email
and any attachments for the presence of viruses. The organization accepts no
liability for any damage caused by any virus transmitted by this email.
_______________________________________________
users mailing list
users@gridengine.org
https://gridengine.org/mailman/listinfo/users
