Hi David,
I added LDAP servers as well as some configuration in Global settings
but nothing appeared after relogging to the system.
Reboot of management did not help either. This is on CS 4.15.
Any tips on how to verify LDAP is being connected properly? May be that
is the cause?
Best regards,
Jordan
-----Original Message-----
From: David Jumani <[email protected]>
Sent: Monday, May 17, 2021 6:52 AM
To: [email protected]
Subject: Re: alternative Active directory config?
[X] This message came from outside your organization
Hi Yordan,
LDAP is enabled in the UI, it'll show up after you add an LDAP server under
Configurations -> LDAP Configurations. Once you've added it log out and log
back in again. You'll then be able to add LDAP users in the accounts section
________________________________
From: Yordan Kostov <[email protected]>
Sent: Thursday, May 13, 2021 6:28 PM
To: [email protected] <[email protected]>
Subject: alternative Active directory config?
Hey everyone,
In 4.15 it seems there is no LDAP config button in the new GUI
or the old GUI, so after LDAP sources are pointed and global config is set
there is no way to actually pin groups to accounts.
* New
https://urldefense.com/v3/__https://imgur.com/K4fN2Ax__;!!A6UyJA!2jofJ4n37vUc_2DvJ48HQLuLnW7s4a1lzIpweetHQqz7GqaUMyyQoUrdSEzRCUhHqDCYuntS6Qas$
* Old
https://urldefense.com/v3/__https://imgur.com/WuAvq4N__;!!A6UyJA!2jofJ4n37vUc_2DvJ48HQLuLnW7s4a1lzIpweetHQqz7GqaUMyyQoUrdSEzRCUhHqDCYuhaIU699$
I was wondering if there is an alternative way to configure LDAP accounts?
Best regards,
Jordan
