By vds - are you meaning VMware Distributed Switches? It sounds like you are not trunking VLANs between your physical hosts fully.
Kind regards, Paul Angus [email protected] www.shapeblue.com 53 Chandos Place, Covent Garden, London WC2N 4HSUK @shapeblue -----Original Message----- From: Asanka Gunasekara [mailto:[email protected]] Sent: 17 November 2017 10:21 To: [email protected] Subject: Re: Unable to access guest hammmmmmmmm, any one! Is it possible to create a working VPC across multiple clusters (Hypervisor is the same) or I am just stuck with rules and routing? Thanks and Regards Asanka On 7 November 2017 at 16:28, Asanka Gunasekara <[email protected]> wrote: > Hi All, can a VPC span across two clusters? > > > Above question is because, I just got it working by creating a seprat > VPC in the new clusre2. > > Thanks and Regards > > Asanka > > On 7 November 2017 at 14:34, Asanka Gunasekara <[email protected]> wrote: > >> Please note I am setting up a POC using trial vmware products >> >> On 7 November 2017 at 14:26, Asanka Gunasekara <[email protected]> wrote: >> >>> Hi All, I have a VMware environment managed by Cloudstack 4.10. >>> Initially I had a single cluster <Cluster1> with two nodes and one VDS. >>> This set-up works fine! Then I created a second cluster <Cluster2> >>> under same datacenter with just one node and the same VDS spans >>> across both >>> cluster1 and cluster2. >>> >>> I can create guest VMs through CloudStack with out any issue and >>> CloudStack assigns IP address with out any issue. And still cluste1 >>> works fine while cluster2 guests dont have network access (hence not >>> getting the ip that was assigned by CloudStack). I tried statically >>> configuring the IP to guest this did not helped either. >>> >>> I think it is something to do with VDS but I am not sure where to >>> start >>> >>> Thanks and Regards >>> >>> Asanka >>> >>> >>> >>> >> >
