Hello Tim, thank you. Now I got the difference.
As far as I understood the Artemis documentation it is possible to configure a cluster and also connect single satellite brokers to this cluster. The satellite brokers can be connected using a bi-directional bridge so I would use the core bridge and would use a network-connector where duplex is set to true. Is this a way I could go? Kind Regards, Andreas On Wed, Dec 6, 2017 at 2:39 PM, Tim Bain <tb...@alumni.duke.edu> wrote: > Networks of brokers use store-and-forward to move messages between the > brokers, and each message is on only one broker at a time so it is lost (at > least temporarily) if that broker goes offline. It's not a cluster under > the definition we just laid out. > > Tim > > On Dec 6, 2017 6:36 AM, "andi welchlin" <andi.welch...@gmail.com> wrote: > > > Hello Tim, > > > > yes, that was exactly my definition. > > > > Maybe I misunderstood the documentation of ActiveMQ "network of brokers". > > > > Kind Regards, > > Andreas > > > > On Wed, Dec 6, 2017 at 2:33 PM, Tim Bain <tb...@alumni.duke.edu> wrote: > > > > > My definition of a cluster is that a given message is available > (without > > > forwarding) from all nodes in the cluster and will remain available > when > > a > > > single node in the cluster is lost. Master-slave pairs are clusters > (but > > > not active-active clusters) under that definition, while a network of > > > brokers is not. > > > > > > So Andi, is that the definition you were using when you wrote this > > > question? > > > > > > Tim > > > > > > On Dec 6, 2017 5:35 AM, "Alec Henninger" <alechennin...@gmail.com> > > wrote: > > > > > > > Isn't network of brokers an active-active cluster? > > > > > > > > On Tue, Dec 5, 2017, 5:21 PM Tim Bain <tb...@alumni.duke.edu> wrote: > > > > > > > > > Not with ActiveMQ 5.x, since it doesn't have a capacity to do an > > > > > active-active cluster, but ActiveMQ Artemis can. Have you looked at > > it? > > > > > > > > > > Tim > > > > > > > > > > On Dec 5, 2017 7:28 AM, "andi welchlin" <andi.welch...@gmail.com> > > > wrote: > > > > > > > > > > > Hello, > > > > > > > > > > > > I would like to setup a active-active cluster of brokers using > > > > ActiveMq. > > > > > > > > > > > > But I also would like to connect single ActiveMq satellite > brokers > > to > > > > > this > > > > > > cluster while they should share some queues and exchanges. So > this > > > will > > > > > be > > > > > > pretty much like a federation between some satellite brokers and > a > > > > > central > > > > > > broker cluster. Clients will connect to these satellite brokers > > using > > > > > AMQP. > > > > > > > > > > > > Do you think this would be possible using ActiveMq? > > > > > > > > > > > > Kind Regards, > > > > > > Andreas > > > > > > > > > > > > > > > > > > > > >
