I had the same case, however, after some tweeks and mainly replacing
realm with the static IP and removing user:password parameter, I can
hardly see 401 in turn log and the request gets authenticated directly,
but I can still find just few in hundreds of lines of turn log.
On 10/20/20 5:00 AM, Maxim Solodovnik wrote:
Correction: just have double checked and there are some 401
This might be the part of SDP
Initial response is 401, then goes authentication part, and then
communication
this can be checked with Wireshark
On Tue, 20 Oct 2020 at 08:54, Maxim Solodovnik <[email protected]
<mailto:[email protected]>> wrote:
On Tue, 20 Oct 2020 at 08:39, [email protected]
<mailto:[email protected]> <[email protected]
<mailto:[email protected]>> wrote:
I had the same question recently.
I can see the same behaviour in Turn Logs. The first request
fails with 401, and subsequent requests get handled and
authenticated.
The connection works, on turn side as well as the media Server
connection works fine. But every connection attempt logs one
401. Even though successfully in the end.
I don't think credentials are wrong. But maybe there is
something with using the authSecret and the user:password at
the same time, the first attempt fails with 401.
Logs on demo have no 401 errors ...
Thanks
Seb
Sebastian Wagner
Director Arrakeen Solutions
http://arrakeen-solutions.co.nz/
<https://www.youracclaim.com/badges/da4e8828-743d-4968-af6f-49033f10d60a/public_url><https://www.youracclaim.com/badges/b7e709c6-aa87-4b02-9faf-099038475e36/public_url>
On Tue, 20 Oct 2020 at 03:51, Ali Alhaidary
<[email protected]
<mailto:[email protected]>> wrote:
Thank you, I was looking into
https://mail-archives.apache.org/mod_mbox/openmeetings-user/202010.mbox/browser
that did not have search :-)
I will try them and return to you.
On 10/19/20 5:13 PM, Maxim Solodovnik wrote:
I would use search in ML archives directly:
https://openmeetings.markmail.org/
this I was able to find this
https://markmail.org/message/d6ifllraemj6dz6v post :))
On Mon, 19 Oct 2020 at 17:23, Ali Alhaidary
<[email protected]
<mailto:[email protected]>> wrote:
when googling it, ideas were conflicting, some say
that this is a legitimate error, even in the ML, the
issue was raided many times, but could not find a
conclusive solution. Would you please send me your
.conf file.
On 10/19/20 11:04 AM, Maxim Solodovnik wrote:
401 means your TURN parameters most probably are
incorrect
were you able to find and check my config? (should
be searchable at ML archives)
On Sun, 18 Oct 2020 at 23:52, Ali Alhaidary
<[email protected]
<mailto:[email protected]>> wrote:
as the above message is so much frequent in turn
log, could the bellow
be the remedy:
https://gitlab.freedesktop.org/gstreamer/gst-plugins-bad/-/issues/1226
--
Best regards,
Maxim
--
Best regards,
Maxim
--
Best regards,
Maxim
--
Best regards,
Maxim
