Thanks Shrikanth
In my test, I have 120MB+ text data, 4 cols. I build index for 2 cols. In compact index. Index size is 340MB+ In first step query, it will also scan all index data. So I think I should choose right cols to create index, and the index size will be more smaller ,is it right? And is it index was sorted? What’s the different in bitmap index , compact index and aggregate index? Best regards Ransom. From: shrikanth shankar [mailto:sshan...@qubole.com] Sent: Saturday, May 12, 2012 12:05 PM To: user@hive.apache.org Subject: Re: how to select without Mapreduce after index build？ My understanding is that the scan of the index is used to remove splits that are known not to contain matching data. If you remove enough splits the second MR task will run much faster. The index should also be much smaller than the base table and that MR task should be much cheaper Shrikanth On May 11, 2012, at 8:56 PM, ransom.hezhiqiang wrote: Thanks Ashish the query will be split into three steps after index build. 1、 query from index table and get the offset. 2、 Move result. 3、 Get select result by offset. So I think the query will be more slow then no index because it has more step and has two mapreduce task in query. So why index exist? No Performance improvements . Best regards Ransom. From: Ashish Thusoo [mailto:athu...@qubole.com] Sent: Saturday, May 12, 2012 12:18 AM To: user@hive.apache.org Cc: Zhaojun (Terry) Subject: Re: how to select without Mapreduce after index build？ Indexing in Hive works through map/reduce. There are no active components in Hive (such as the region servers in Hbase), so the way the index is basically used is by running the map/reduce job on the table that holds the index data to get all the relevant offsets into the main table and then using those offsets to figure out which blocks to read from the main table. So you will not see map/reduce go away even when you are running queries on tables with indexes on them. Ashish On Thu, May 10, 2012 at 11:32 PM, Hezhiqiang (Ransom) <ransom.hezhiqi...@huawei.com> wrote: I think if I create index for one table When I excute “select c1,c2 from tab where index_col=1”, should not start mapreduce But it was start . So how to use a index without mapreduce? Compact index and bitmap index all was tested , all need mapreduce .
