Folks - Please let me know if you have any advice on this question. Thanks
On Saturday, November 16, 2019, 02:39:18 PM EST, M Singh
<mans2si...@yahoo.com> wrote:
Hi:
I have a Flink job and sometimes I need to cancel and re run it. From what I
understand the checkpoints for a job are saved under the job id directory at
the checkpoint location. If I run the same job again, it will get a new job id
and the checkpoint saved from the previous run job (which is saved under the
previous job's id dir) will not be used for this new run. Is that a correct
understanding ? If I need to re-run the job from the previous checkpoint - is
there any way to do that automatically without using a savepoint ?
Also, I believe the internal job restarts do not change the job id so in those
cases where the job restarts will pick the state from the saved checkpoint. Is
my understanding correct ?
Thanks
Mans
