Mahdi, you don’t need to re-read at CL ONE on line 9. When a LWT statement is not applied, the values that prevented the LWT are returned as part of the response, I’d expect them to be more consistent than your read. I’m not 100% sure it’s the case for 2.0.x but it’s the case for Cassandra 2.2.
And it’s the same for line 1, you should only keep your LWT statement unless you have a huge performance benefit of doing. In Cassandra doing a read before write is a bad pattern. AFAIK a LWT statement is always executed as SERIAL, the only choice you have is between SERIAL and LOCAL_SERIAL. Regards, -- Jacques-Henri Berthemet From: DuyHai Doan [mailto:doanduy...@gmail.com] Sent: Sunday, February 11, 2018 6:11 PM To: user <user@cassandra.apache.org> Subject: Re: LWT broken? Mahdi , the issue in your code is here: else // we lost LWT, fetch the winning value 9 existing_id = SELECT id FROM hash_id WHERE hash=computed_hash | consistency = ONE You lost LWT, it means that there is a concurrent LWT that has won the Paxos round and has applied the value using QUORUM/SERIAL. In best case, it means that the won LWT value has been applied to at least 2 replicas out of 3 (assuming RF=3) In worst case, the won LWT value has not been applied yet or is pending to be applied to any replica Now, if you immediately read with CL=ONE, you may: 1) Read the staled value on the 3rd replica which has not yet received the correct won LWT value 2) Or worst, read a staled value because the won LWT is being applied when the read operation is made That's the main reason reading with CL=SERIAL is recommended (CL=QUORUM is not sufficient enough) Reading with CL=SERIAL will: a. like QUORUM, contact strict majority of replicas b. unlike QUORUM, look for validated (but not yet applied) previous Paxos round value and force-applied it before actually reading the new value On Sun, Feb 11, 2018 at 5:36 PM, Mahdi Ben Hamida <ma...@signalfx.com<mailto:ma...@signalfx.com>> wrote: Totally understood that it's not worth (or it's rather incorrect) to mix serial and non serial operations for LWT tables. It would be highly satisfying to my engineer mind if someone can explain why that would cause issues in this particular situation. The only explanation I have is that a non serial read may cause a read repair to happen and that could interfere with a concurrent serial write, although I still can't explain how that would cause two different "insert if not exist" transactions to both succeed. -- Mahdi. On 2/9/18 2:40 PM, Jonathan Haddad wrote: If you want consistent reads you have to use the CL that enforces it. There’s no way around it. On Fri, Feb 9, 2018 at 2:35 PM Mahdi Ben Hamida <ma...@signalfx.com<mailto:ma...@signalfx.com>> wrote: In this case, we only write using CAS (code guarantees that). We also never update, just insert if not exist. Once a hash exists, it never changes (it may get deleted later and that'll be a CAS delete as well). -- Mahdi. On 2/9/18 1:38 PM, Jeff Jirsa wrote: On Fri, Feb 9, 2018 at 1:33 PM, Mahdi Ben Hamida <ma...@signalfx.com<mailto:ma...@signalfx.com>> wrote: Under what circumstances would we be reading inconsistent results ? Is there a case where we end up reading a value that actually end up not being written ? If you ever write the same value with CAS and without CAS (different code paths both updating the same value), you're using CAS wrong, and inconsistencies can happen.