Consider this output from nodetool ring:
Address DC Rack Status State Load
Effective-Ownership Token
127605887595351923798765477786913079396
dc1.5 DC1 RAC1 Up Normal 32.07 GB 50.00%
0
dc2.100 DC2 RAC1 Up Normal 8.21 GB 50.00%
100
dc1.6 DC1 RAC1 Up Normal 32.82 GB 50.00%
42535295865117307932921825928971026432
dc2.101 DC2 RAC1 Up Normal 12.41 GB 50.00%
42535295865117307932921825928971026532
dc1.7 DC1 RAC1 Up Normal 28.37 GB 50.00%
85070591730234615865843651857942052864
dc2.102 DC2 RAC1 Up Normal 12.27 GB 50.00%
85070591730234615865843651857942052964
dc1.8 DC1 RAC1 Up Normal 27.34 GB 50.00%
127605887595351923798765477786913079296
dc2.103 DC2 RAC1 Up Normal 13.46 GB 50.00%
127605887595351923798765477786913079396
I concealed IPs and DC names for confidentiality.
All of the data loading was happening against DC1 at a pretty brisk
rate, of, say, 200K writes per minute.
Note how my tokens are offset by 100. Shouldn't that mean that load on
each node should be roughly identical ? In DC1 it is roughly around 30
G on each node. In DC2 it is almost 1/3rd of the nearest DC1 node by
token range.
To verify that the nodes are in sync, I ran nodetool -h localhost
repair MyKeySpace --partitioner-range on each node in DC2. Watching the
logs, I see that the repair went really quick and all column families
are in sync!
I need help making sense of this. Is this because DC1 is not fully
compacted ? Is it because DC2 is not fully synced and I am not checking
correctly ? How can I tell that there is still replication going on in
progress (note, I started my load yesterday at 9:50am).
--
Regards,
Oleg Dulin
http://www.olegdulin.com
