There on old LED Cinema display that was not worth seeing (slightly dimmed) and I tried hooked it up my may book program on with the 32inch LG curved display, this giving three monitors. The effective working screenrect(s) are as follows
0,455,3440,1872 # Display 1 the LG -1680,1463,0,2490 # Display 2, the LED Cinema display -2560,23,0,1440 # my MacPowerbook The problem in the arrangement is: if I set the LC IDE to open on any of these, the stacks in my app open where I expect to but Stack "revNewScriptEditor 1" (SE) 0,454,1264,1456 So to the Prefs stack, ) revPreferencesGUI Property Inspector Fortunately there is a work around. I open script editor. Set the working rect to 0,600,1264,1456 # this get the whole the screen. Then you *must* make change, like add what space, save the editor in it's new location. Had to fiddle the rect of revPreferencesGUI also. Save. Then quit LC and open in again. It in the new location. I realize how tricky it would be... perhaps this should be a "resetToNewMonitorSpace" space which wipes the loc the IDE stack and relocates them in relation to the rect on the revMenuBar, which appears in the right locations. The rect of other stacks could be set to +100 on topLeft. [fake code] Put rect with revMenuBar to tRelocate Put (item 1 of tRelocate + 100) into tLeft Put( item 1 of tRelocate +100) into tTop Repeat [for all stacks x in IDE] Set rects of stack [x] Set the topLeft for stack [x] to tLeft,tTop ## offset they don't appear in top of each other Add 20 to tLeft Add 20 to tTop End repeat Brahmanathaswami _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode